RabbitLink EG2110 Manuel d'utilisateur télécharger pdf (Page 10)

6 RabbitLink (EG2110)

By default, the RabbitLink will try to get an IP address using DHCP. (DHCP is a protocol

to automatically assign IP addresses to computers when they are booted.) The network

addresses may be changed using the RabbitLink serial console. Please see Appendix 2.2,

“Configuring RabbitLink Network Parameters from your PC,” for more information.

If your PC is not connected to a network you may create a network using a hub or you may

use a crossover Ethernet cable to make the connection directly from you PC’s Ethernet

adapter to the RabbitLink card. If you are already connected to a network it may be neces-

sary for the network administrator to assign an IP address to be used by the RabbitLink.

1.4.3 Passphrase Protection

Every time Dynamic C initiates a new RabbitLink session, the RabbitLink requests a pass-

phrase from the user to ensure the security of the programs and data on the remote boards.

This passphrase is stored by Dynamic C during that session so it only needs to be entered

the first time Dynamic C contacts the RabbitLink gateway. For security reasons, Dynamic

C does not store the passphrase on the hard disk of the PC.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 57 58

Pas de commentaire

RabbitLink EG2110 Manuel d'utilisateur Page 10